====== Safety instructions ====== #;; Neuron #;; {{page>..:safety-intro-hidden}} ===== Symbols and notes ===== The safety signs and notices below are used across the entire [[.#documentation_overview|online documentation]]. ---- {{page>..:symbols-notes-hidden}} ===== General safety notice ===== {{page>..:general-safety-hidden}} ===== Electrical safety ===== * Ensure that the power supply voltage matches the specified values indicated on the device label or in the [[technical-parameters#power_supply|technical parameters]]. Using an incorrect power source may cause damage to the device and/or connected peripherals. /* * Use only the recommended fuses and circuit breakers that meet the manufacturer's specifications. */ * Do not connect the device to power if it is damaged or shows signs of malfunction. * Ensure that wires/cables are installed with proper strain relief. * Wires/cables must not be exposed to mechanical damage or environmental conditions that could degrade the cable isolation. {{ :files:img_warning-line_o.png?nolink |}} {{ :en:hw:02_safety-instructions_ISO-7010-W012.png?nolink |/↯\}} **Warning**: \\ Take extra care when plugging in, there is a risk of electric shock! Always disconnect the device from all voltage sources (power supply, relays, etc.) before installation or maintenance. ===== Installation and mounting ===== * Installation must be carried out by a qualified person in accordance with local electrical regulations. * Ensure compliance with the [[technical-parameters#storage_installation_and_operating_conditions|operating and installation conditions]] when installing the device. * Ensure that terminal blocks and electrical connections are firmly tightened and correctly wired. * The device is designed for installation in a distribution cabinet, where adequate cooling and ventilation must be ensured. If the spontaneous air circulation in the cabinet is not sufficient, airflow must be ensured by installing a fan. * Ensure separation of AC voltage cabling or high-voltage DC circuits with high-frequency switching cycles from signal wires and buses. * Keep cable lengths as short as possible. For longer cables or depending on the environment, use shielded cables. {{ :files:img_warning-line_o.png?nolink |}} {{ :en:hw:01_safety-instructions_ISO-7010-W001.png?nolink |/!\}} **Warning**: \\ Improper handling may result in significant property damage, injury, or death. The cabinet in which the device is installed must be accessible only with a key or special tool. Only authorized personnel may have access to the device. {{ :files:img_breakline_2.png?nolink |}} The device may only be installed indoors and in an environment that meets the [[technical-parameters#storage_installation_and_operating_conditions|product specifications]] (interiors with suitable temperature and humidity, cabinets protected from water ingress, etc.). ==== DIN mounting ==== {{page>..:din-mounting-hidden}} ===== Operational safety ===== * Use the device only for the purpose for which it was designed. * Ensure compliance with the [[technical-parameters#operating_installation_and_storage_conditions|operating parameters]] of the device. * Do not use the device in environments with extreme temperatures, high humidity, or chemical vapors. * Do not expose the device to direct sunlight or heat sources. * The maximum temperature of the air entering the device must not exceed the values specified in the operating parameters. * Do not overload the device beyond its rated values. * If abnormal operation occurs (e.g. overheating, burning smell, smoke), immediately disconnect the equipment from the power supply and contact service. {{ :files:img_warning-line_r.png?nolink |}} {{ :en:hw:01_safety-instructions_ISO-7010-W001.png?nolink |/!\}} **Danger**: \\ Never use the device in areas with an explosion hazard! ===== Maintenance and service ===== {{page>..:maintenance-service-hidden}} ==== DIN demounting ==== {{page>..:din-demounting-hidden}} ===== Environmental protection and disposal ===== {{page>..:enviromental-protection-hidden}}