====== Flashing the OS using the service interface ====== To upload OS into the Unipi Gate through its service interface, you need to access the service mode first. To enable it, follow instructions [[en:hw:025-gate:service-mode|in this article]]. - Enter the device's IP address into a web browser. Upon confirmation, you will be connected to the Unipi Gate service interface - In the service interface, drag and drop the **archive.swu** file extracted from the OS image archive into the **Software update** dialogue window - The flashing process is indicated by rapid blinking of **ACT**, **TX** and **RX** diodes ([[en:hw:025-gate:led-indication#pwr_is_on_the_rest_blinks_rapidly_80_ms|demonstration here]]) - Wait until the device finishes the process. Its progress can be monitored in a dialogue window under the **Messages** label - Finishing the process is indicated by diodes going off and a reboot of the device ====== Flashing the OS using a USB flashdisk ====== - Prepare a USB flash disk in FAT32 format with a capacity of at least 2 GB - Copy the content of the ZIP archive onto the flash disk - Unplug the power supply from the device and insert the flash disk into the device's USB port - Press **and hold** the **SERVICE** button on the device's face side - Plug the power supply back. Unipi Gate will automatically start the OS flashing process indicated by rapid blinking of **ACT**, **TX** and **RX** diodes ([[en:hw:025-gate:led-indication#pwr_is_on_the_rest_blinks_rapidly_80_ms|demonstration here]]) - You can now release the SERVICE button - Finishing the process is indicated by diodes going off and a reboot of the device {{ :files:img_warning-line_b.png?nolink |}} {{ :en:hw:08_safety-instructions_pseudo-ISO-7010-info.png?nolink |(i)}} **Note:** \\ If the USB flash disk is not compatible, Unipi Gate will not start the OS flashing and reboots. In that case, you need to use a different flash disk or the above-mentioned flashing through [[#flashing_os_using_the_service_interface|the service interface]].