(!)

Note:
The operating latch can be locked in 4 positions in the base, one of which is not compatible with Unipi Edge. To ensure that any alteration to the locking position is carried out easily and safely, when the base is being inserted or removed its upper section should be pressed in gently by hand. At the same time the operating latch must be pushed out. This also prevents any possible damage to the locking lugs in the latch guide.

/!\

Warning:
Prior to mounting, make sure that the environment is disconnected from all power sources.

If the holder for DIN rail is not installed, it must be mounted first with the supplied screws (2x M3x7 mm, button head) so that the hook of the extension spring is on the bottom and facing towards front of the device.

DIN holder installation

To install unit on the DIN rail, slide the unit onto the rail from above (in the direction of arrow 1 and 2 in the picture below) and then pull the extension spring down with screwdriver and lightly push the device (in the direction of arrow 3 in the picture below) until flush with DIN rail.

Mounting on DIN rail

(!)

Attention:
Avoid pressure on the terminals as they could be mechanically damaged.