Secondary ethernet configuration
Some of our units are equipped with secondary ethernet interface. In this tutorial, we will cover the configuration of this interface in Mervis.
Axon S155
Gate
Mervis 2.6.5 and newer do not use this way of configuring anymore, please refer to this article.
The possible settings of the second interface include:
- Static IP or DHCP client
- Bridge interface for a primary network (e.g both interfaces act as a switch)
- Secondary ethernet cannot act as a backup internet connectivity
- PLC cannot act as a router between networks
In your solution, left-click on the PLC in the Left panel, move over to the Properties panel, scroll down until you find a section called “Advanced Network Configuration” and click on the 
sign to reveal more properties.
Locate the subsection called “Network card”:
The options are:
- Name: internal name of the interface, it cannot be changed and you will not see it anywhere else
- Enabled: When disabled, the interface will be put into a bridge mode together with a primary network interface. When enabled, following IP settings will take effect
- IP Configuration: Whether the IP will be set manually or taken from DHCP server
- IP Address: static IP address for the interface, to be used together with IP Configuration = Static
- Netmask: netmask of the IP range, to be used together with IP Configuration = Static
Change the settings according to your dispositions.
These options change the configuration of the MervisRT. As such, the configuration cannot be applied by deploying the project, but rather through “Upload configuration”. Right-click on the PLC in the Left Panel, then on the PLC Operation → PLC Setup → Upload configuration. If you are not sure, check out the Uploading a RunTime configuration tutorial.