Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
en:automation:poe-splitter-hidden [2023/11/27 19:21] avsetula [Powering Unipi units through PoE] |
en:automation:poe-splitter-hidden [2023/11/27 19:22] avsetula [Technical data] |
||
|---|---|---|---|
| Line 27: | Line 27: | ||
| - connect the splitter’s V+ clamp to the PLC’s 24V clamp | - connect the splitter’s V+ clamp to the PLC’s 24V clamp | ||
| - connect the splitter’s V- clamp to the PLC’s GND clamp | - connect the splitter’s V- clamp to the PLC’s GND clamp | ||
| - | - using the network cable, connect the splitter’s **Data Out** port with the PLC’s **ETH** port | + | - using the network cable, connect the splitter’s **Data Out** port with the controller’s **ETH** port |
| - plug an 802.3at PoE+ compatible network cable into the splitter‘s **PoE In** port | - plug an 802.3at PoE+ compatible network cable into the splitter‘s **PoE In** port | ||
| Line 34: | Line 34: | ||
| - connect the WAN network cable into the **Ethernet** port | - connect the WAN network cable into the **Ethernet** port | ||
| ==== Technical data ==== | ==== Technical data ==== | ||
| - | Using a single splitter to power multiple PLCs is not recommended! | + | Using a single splitter to power multiple controllers is not recommended! |
| \\ | \\ | ||
| \\ | \\ | ||
