Differences

This shows you the differences between two versions of the page.

--- en:hw:01-axon:backup2usb [2020/06/29 10:42]
127.0.0.1 external edit
+++ en:hw:01-axon:backup2usb [2020/06/29 13:47]
martyy [Backup process]
@@ Line 7: / Line 7: @@
 ====== Backup process ======
-<WRAP center round important 90%>
+<WRAP center round alert 90%>
-The backup process does work only via the service web interface, do not put the content of the backup2usb.zip to the USB flash and try to start the backup process from it as it will result in bricking the Axon.
+During the image recovery process, all data from the recovered PLC unit is permanently deleted and the storage partition-table is reset to the factory default state.
+</WRAP>
+<WRAP center round alert 90%>
+The tool requires a default partitioning of internal storage. If the number/type/size of any partitions is changed by the user, the backup/recovery process may not work properly.
 </WRAP>
 <WRAP center round alert 90%>
-/* FIXME MT: doplnit info o prekopani partitions + kompatibilita USB2/3 flashek */
+USB 3.0 flash drives may not work properly on older Axon PLC units. A USB 2.0 flash drive is recommended. The drive must always be formatted with the FAT32 file system.
 </WRAP>
-  - Download and extract the backup2usb SWU: {{ :en:hw:01-axon:unipi-backup2usb-1.6.zip |}}
+  - Download and extract the backup2usb tool: {{ :en:hw:01-axon:unipi-backup2usb-1.6.zip |}}
   - Start the Axon in service mode:
     - Hold and keep pressed the small recessed button on top of the Axon device case using a thin-enough tool. The button can be found next to the USB port labels on the upper side of the device.