Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
en:hw:01-axon:backup2usb [2020/06/29 10:52] tomhora |
en:hw:01-axon:backup2usb [2020/06/29 13:47] martyy [Backup process] |
||
---|---|---|---|
Line 7: | Line 7: | ||
====== Backup process ====== | ====== Backup process ====== | ||
- | <WRAP center round important 90%> | + | <WRAP center round alert 90%> |
- | The backup process does work only via the service web interface, do not put the content of the backup2usb.zip to the USB flash and try to start the backup process from it as it will result in bricking the Axon. | + | During the image recovery process, all data from the recovered PLC unit is permanently deleted and the storage partition-table is reset to the factory default state. |
+ | </WRAP> | ||
+ | <WRAP center round alert 90%> | ||
+ | The tool requires a default partitioning of internal storage. If the number/type/size of any partitions is changed by the user, the backup/recovery process may not work properly. | ||
</WRAP> | </WRAP> | ||
<WRAP center round alert 90%> | <WRAP center round alert 90%> | ||
- | /* FIXME MT: doplnit info o prekopani partitions + kompatibilita USB2/3 flashek */ | + | USB 3.0 flash drives may not work properly on older Axon PLC units. A USB 2.0 flash drive is recommended. The drive must always be formatted with the FAT32 file system. |
</WRAP> | </WRAP> | ||