Differences

This shows you the differences between two versions of the page.

--- en:hw:din-mounting-bopla-hidden [2025/05/22 11:11] – changed links ofojt
+++ en:hw:din-mounting-bopla-hidden [2026/07/28 10:19] (current) – fix wrap ofojt
@@ Line 2: / Line 2: @@
 INCLUDED IN:
 - en:hw:004-edge:safety-instructions
-- en:hw:004-edge:01-first-steps
 */
+{{page>.:din-mount-bopla-position-hidden}}
 <WRAP group center round box 95%>
@@ Line 16: / Line 18: @@
 </WRAP>
-If the holder for DIN rail is not installed, it must be mounted first with the supplied screws (M3x7, DIN 84, ZN) so that the hook of the extension spring is on the bottom and facing towards front of the device.
+If the holder for DIN rail is not installed, it must be mounted first with the supplied screws (2x M3x7 mm, button head) so that the hook of the extension spring is on the bottom and facing towards front of the device.
 ;#;
@@ Line 23: / Line 25: @@
 {{ .:01_edge_mount_tsh-35.png?direct&620 |}}
-To install unit on the DIN rail, slide the unit onto the rail from above (in the direction of arrow 1 in the picture below) and then pull the extension spring down with screwdriver and lightly push the device (in the direction of arrow 2 in the picture below) until flush with DIN rail.
+To install unit on the DIN rail, slide the unit onto the rail from above (in the direction of arrow 1 and 2 in the picture below) and then pull the extension spring down with screwdriver and lightly push the device (in the direction of arrow 3 in the picture below) until flush with DIN rail.
 ;#;
@@ Line 37: / Line 39: @@
 <WRAP half column 83%>
 **Attention**: \\
-Avoid pressure on the inputs/outputs as they could be mechanically damaged.
+Avoid pressure on the terminals as they could be mechanically damaged.
-</WRAP>
-</WRAP>
-<WRAP group center round box 95%>
-{{ :files:img_warning-line_y.png?nolink |}}
-<WRAP half column 13%>
-{{ :en:hw:01_safety-instructions_ISO-7010-W001.png?nolink |/!\}}
-</WRAP>
-<WRAP half column 83%>
-**Caution**: \\
-Make sure that the upper edge of the DIN rail runs between the spring and the rear of the DIN holder (see figure above). Improper mounting of the DIN bracket can cause injury when mounted on the DIN rail.
 </WRAP>
 </WRAP>