Differences

This shows you the differences between two versions of the page.

--- en:hw:din-mounting-bopla-hidden [2025/07/21 06:13] – added head type ofojt
+++ en:hw:din-mounting-bopla-hidden [2026/07/28 10:19] (current) – fix wrap ofojt
@@ Line 2: / Line 2: @@
 INCLUDED IN:
 - en:hw:004-edge:safety-instructions
-- en:hw:004-edge:01-first-steps
 */
+{{page>.:din-mount-bopla-position-hidden}}
 <WRAP group center round box 95%>
@@ Line 16: / Line 18: @@
 </WRAP>
-If the holder for DIN rail is not installed, it must be mounted first with the supplied screws (M3x7, button head) so that the hook of the extension spring is on the bottom and facing towards front of the device.
+If the holder for DIN rail is not installed, it must be mounted first with the supplied screws (2x M3x7 mm, button head) so that the hook of the extension spring is on the bottom and facing towards front of the device.
 ;#;
@@ Line 23: / Line 25: @@
 {{ .:01_edge_mount_tsh-35.png?direct&620 |}}
-To install unit on the DIN rail, slide the unit onto the rail from above (in the direction of arrow 1 in the picture below) and then pull the extension spring down with screwdriver and lightly push the device (in the direction of arrow 2 in the picture below) until flush with DIN rail.
+To install unit on the DIN rail, slide the unit onto the rail from above (in the direction of arrow 1 and 2 in the picture below) and then pull the extension spring down with screwdriver and lightly push the device (in the direction of arrow 3 in the picture below) until flush with DIN rail.
 ;#;