en:hw:din-mounting-bopla-hidden [Unipi technology Knowledge Base]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

/*
INCLUDED IN:
- en:hw:004-edge:safety-instructions
*/


{{page>.:din-mount-bopla-position-hidden}}

<WRAP group center round box 95%>
{{ :files:img_warning-line_o.png?nolink |}}
<WRAP half column 13%>
{{ :en:hw:07_safety-instructions_iso-7010-m021.png?nolink |/!\}}
</WRAP>
<WRAP half column 83%>
**Warning**: \\
Prior to mounting, make sure that the environment is disconnected from all power sources.
</WRAP>
</WRAP>

If the holder for DIN rail is not installed, it must be mounted first with the supplied screws (2x M3x7 mm, button head) so that the hook of the extension spring is on the bottom and facing towards front of the device.

;#;
//DIN holder installation//
;#;
{{ .:01_edge_mount_tsh-35.png?direct&620 |}}

To install unit on the DIN rail, slide the unit onto the rail from above (in the direction of arrow 1 and 2 in the picture below) and then pull the extension spring down with screwdriver and lightly push the device (in the direction of arrow 3 in the picture below) until flush with DIN rail.

;#;
//Mounting on DIN rail//
;#;
{{ .:02_edge_mount_tsh-35.png?direct&320 |}}

<WRAP group center round box 95%>
{{ :files:img_warning-line_b.png?nolink |}}
<WRAP half column 13%>
{{ :en:hw:09_safety-instructions_pseudo-iso-7010-attention.png?nolink |(!)}}
</WRAP>
<WRAP half column 83%>
**Attention**: \\
Avoid pressure on the terminals as they could be mechanically damaged.
</WRAP>
</WRAP>