Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
en:sw:01-mervis:07-certification [2020/01/08 07:36] jan_kozak [Room temperature and lighting control] |
en:sw:01-mervis:07-certification [2020/02/13 08:20] jan_kozak |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| ===== Room temperature and lighting control ===== | ===== Room temperature and lighting control ===== | ||
| - | Your task is to create a system for controlling heating and lighting in a single room. All required components are contained in the certification kit. Start with building the kit, using {{ :en:sw:01-mervis:schema_xs10.pdf |this connection scheme}} as a guide. | + | Your task is to create a system for controlling heating and lighting in a single room. All required components are contained in the certification kit. Start with building the kit, using {{ :cs:sw:01-mervis:schema_xs11.pdf |this connection scheme}} as a guide. |
| Room heating control consists of: | Room heating control consists of: | ||
| Line 32: | Line 32: | ||
| Assembly of the certification kit | Assembly of the certification kit | ||
| - | * fasten DIN rail holders to both the Axon S105 controller and the xS10 extension module using the provided screws | + | * fasten DIN rail holders to both the Axon S105 controller and the xS11 extension module using the provided screws |
| - | * mount the controllers, terminals and relays to the DIN rail according to {{:en:sw:01-mervis:schema_xs10.pdf |this scheme}} | + | * mount the controllers, terminals and relays to the DIN rail according to {{:cs:sw:01-mervis:schema_xs11.pdf |this scheme}} |
| * interconnect blue terminals with the 2-way jumper | * interconnect blue terminals with the 2-way jumper | ||
| * interconnect red and grey terminals with the 3-way jumper | * interconnect red and grey terminals with the 3-way jumper | ||
| * insert the resistance housing into the grey terminal | * insert the resistance housing into the grey terminal | ||
| - | * connect all cables and conductors according to {{:en:sw:01-mervis:schema_xs10.pdf |the scheme}} | + | * connect all cables and conductors according to {{:cs:sw:01-mervis:schema_xs11.pdf |the scheme}} |
| * prior to connecting the power source, check the correct voltage polarity | * prior to connecting the power source, check the correct voltage polarity | ||
