Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:sw:01-mervis:creating-new-project-hidden [2021/09/08 08:40] avsetula [Switching to Full Mode] |
en:sw:01-mervis:creating-new-project-hidden [2024/01/24 09:30] (current) avsetula [Uploading a blank configuration] |
||
---|---|---|---|
Line 1: | Line 1: | ||
<html><div class="version-switch"> | <html><div class="version-switch"> | ||
- | <a href="#first_project_with_a_unipi_unit"><div class="actual-version">IDE v2.4.0</div></a> | + | <a href="#first_project_with_a_unipi_unit"><div class="actual-version">IDE v2.3.0 and later</div></a> |
- | <a href="#first_project_with_a_unipi_unit"><div class="actual-version">IDE v2.3.0</div></a> | + | |
</div></html> | </div></html> | ||
====== First project with a Unipi unit ====== | ====== First project with a Unipi unit ====== | ||
Line 109: | Line 108: | ||
Now we move to the configuration. This part is especially important if you are just starting a new project with a controller or expansion modules that have been used in the past. That's because these devices may have a previous configuration that is independent of the uploaded solution, even the operating system, and may unexpectedly affect the operation of the entire solution. | Now we move to the configuration. This part is especially important if you are just starting a new project with a controller or expansion modules that have been used in the past. That's because these devices may have a previous configuration that is independent of the uploaded solution, even the operating system, and may unexpectedly affect the operation of the entire solution. | ||
- | There is no need to worry, just right-click on the modbus table named after the assigned controller in the current clean project and select **Configure Unipi module**. This will load the default configuration. Detailed description of this procedure is in the article: [[cs:sw:01-mervis:unipi-configure-module-hidden|Konfigurace modulu Unipi]]. | + | There is no need to worry, just right-click on the modbus table named after the assigned controller in the current clean project and select **Configure Unipi module**. This will load the default configuration. Detailed description of this procedure is in the article: [[en:sw:01-mervis:unipi-configure-module-hidden|]]. |
{{ :en:sw:01-mervis:12_creating-new-project_en.png?direct |}} | {{ :en:sw:01-mervis:12_creating-new-project_en.png?direct |}} |