Differences

This shows you the differences between two versions of the page.

--- en:sw:01-mervis:unipi-configure-module-hidden [2021/06/04 13:26]
avsetula
+++ en:sw:01-mervis:unipi-configure-module-hidden [2021/06/07 05:22]
lpolcerova
@@ Line 14: / Line 14: @@
 </WRAP>
-<WRAP center round tip 60%>
+<WRAP center round tip 90%>
 All of these configurations are OS-independent and are permanently stored into the modules. If you receive an used Unipi unit, the best approach is to save a blank new configuration to overwrite possible unwanted settings.
 </WRAP>
+/* FIXME - přeložit do EN - přeloženo
+<WRAP center round important 90%>
+After changing parameters for serial lines **ttyNS** (see: port mapping table for [[en:hw:007-patron:portmap|Patron]]/[[en:hw:02-neuron:portmap|Neuron]]/[[en:hw:01-axon:portmap|Axon]]) it is then necessary to upload the configuration to the controller. Before uploading the configuration, always make sure that the other settings (output mode, default values, etc.) are set correctly.
+If the configuration is not loaded after changing the serial line settings, the serial line configuration may be reset when the I/O board is restarted.
+</WRAP>
+*/
 In Mervis, the configuration is pushed via context menu of the connected prototype. Right click on the prototype name in the **Left Panel** and in the context menu click on "**Unipi - Configure Module**".