Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:sw:01-mervis:unipi-configure-module-hidden [2021/06/04 13:26] avsetula |
en:sw:01-mervis:unipi-configure-module-hidden [2021/06/07 06:48] (current) avsetula |
||
---|---|---|---|
Line 14: | Line 14: | ||
</WRAP> | </WRAP> | ||
- | <WRAP center round tip 60%> | + | |
+ | <WRAP center round tip 90%> | ||
All of these configurations are OS-independent and are permanently stored into the modules. If you receive an used Unipi unit, the best approach is to save a blank new configuration to overwrite possible unwanted settings. | All of these configurations are OS-independent and are permanently stored into the modules. If you receive an used Unipi unit, the best approach is to save a blank new configuration to overwrite possible unwanted settings. | ||
</WRAP> | </WRAP> | ||
- | + | ||
+ | <WRAP center round important 90%> | ||
+ | After changing parameters for serial lines **ttyNS** (see: port mapping table for [[en:hw:007-patron:portmap|Patron]]/[[en:hw:02-neuron:portmap|Neuron]]/[[en:hw:01-axon:portmap|Axon]]) it is then necessary to upload the configuration to the controller. Before uploading the configuration, always make sure that the other settings (output mode, default values, etc.) are set correctly. | ||
+ | |||
+ | If the configuration is not loaded after changing the serial line settings, the serial line configuration may be reset when the I/O board is restarted. | ||
+ | </WRAP> | ||
In Mervis, the configuration is pushed via context menu of the connected prototype. Right click on the prototype name in the **Left Panel** and in the context menu click on "**Unipi - Configure Module**". | In Mervis, the configuration is pushed via context menu of the connected prototype. Right click on the prototype name in the **Left Panel** and in the context menu click on "**Unipi - Configure Module**". | ||