Differences

This shows you the differences between two versions of the page.

--- en:sw:01-mervis:updating-a-runtime-configuration-hidden [2020/04/28 17:57]
89.142.197.56 ↷ Links adapted because of a move operation
+++ en:sw:01-mervis:updating-a-runtime-configuration-hidden [2021/08/05 14:44]
avsetula [Uploading a RunTime configuration]
@@ Line 1: / Line 1: @@
 ====== Uploading a RunTime configuration ======
+<WRAP group>
+<WRAP half column 81%>
 Each time you wish to upload RT configuration changes, make sure, that you downloaded the PLC config beforehand. We also recommend to double-check settings of your network card and make sure it is compatible with the required configuration (mainly if the DHCP client is enabled). After these checks, set the configuration.
+</WRAP>
+<WRAP half column 15%>
+;;#
+<html><span class="dev-tag dev-patron">Patron</span></html> \\
+<html><span class="dev-tag dev-neuron">Neuron</span></html> \\
+<html><span class="dev-tag dev-gate">Gate</span></html> \\
+<html><span class="dev-tag dev-unipi11">Unipi&nbsp1.1</span></html> \\
+<html><span class="dev-tag dev-axon">Axon</span></html>
+;;#
+</WRAP>
+</WRAP>
 After finishing the configuration, right-click on the PLC, select <html><span class="avBlueText">PLC Operation</span></html> -> <html><span class="avBlueText">PLC Setup</span></html> -> <html><span class="avBlueText">Upload configuration</span></html>
@@ Line 18: / Line 30: @@
 <WRAP center round important 80%>
-**Caution:** if you are unable to upload configuration, upload a new project etc. after a password change, the most likely cause is you uploaded a wrong password by error. If you can't remember the correct password, you can reflash the PLC's operating system as a last-resort solution. See the corresponding guides for [[en:hw:01-axon:image|Unipi Axon]] and [[en:sw:01-mervis:running-on-neuron-hidden|Unipi Neuron/Unipi 1.1]].
+**Caution:** if you are unable to upload configuration, upload a new project etc. after a password change, the most likely cause is you uploaded a wrong password by error. If you can't remember the correct password, you can reflash the PLC's operating system as a last-resort solution. See the corresponding guides for [[en:hw:007-patron:image|Unipi Patron]], [[en:hw:01-axon:image|Unipi Axon]] and [[en:sw:01-mervis:running-on-neuron-hidden|Unipi Neuron/Unipi 1.1]].
 </WRAP>