Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
en:sw:04-unipi-firmware [2020/05/22 12:02] tomhora [Firmware] |
en:sw:04-unipi-firmware [2020/05/22 12:56] tomhora [Firmware] |
||
---|---|---|---|
Line 91: | Line 91: | ||
<WRAP center round info 80%> | <WRAP center round info 80%> | ||
- | The -p (path) parameter must be set according to the used serial for the extension - see the [[en:hw:01-axon:portmap|]] to find proper serial port within your unit. For example, if extension is connected to //RS485-1/RS485-1.1//: <code>/opt/unipi/tools/fwserial -p /dev/ttyNS0 -P </code>. | + | The -p (path) parameter must be set according to the used serial for the extension - see the [[en:hw:01-axon:portmap|]] or [[en:hw:02-neuron:portmap|]]to find proper serial port within your unit. For example, if extension is connected to //RS485-1/RS485-1.1//: <code>/opt/unipi/tools/fwserial -p /dev/ttyNS0 -P </code>. |
Note that the fwserial assumes that extension‘s Modbus address, baud rate and parity are in the factory-default state, ie **19200 baud 8N1 with address 15**. | Note that the fwserial assumes that extension‘s Modbus address, baud rate and parity are in the factory-default state, ie **19200 baud 8N1 with address 15**. | ||
</WRAP> | </WRAP> |