The production of Unipi Axon units was discontinued and no longer receive software updates. The Axon line was replaced by the Unipi Patron.
Each Axon unit contains Debian-based OS and is supplied with a pre-installed Mervis software solution by default. The OS can be however reflashed for any other compatible software you wish to install.
Axon
Flashing OS via the service interface on Axon units can be performed in three ways:
1) In a local network (with DHCP):
2) Direct connection to the unit (without DHCP):
192.168.200.100
, mask 255.255.255.0
192.168.200.200
3) Via a Wi-Fi hotspot
UNIPICONFIG
, using unipi.technology
as password. Wait until your unit obtains an IP address from the DHCP server running in the unit192.168.201.1
Next steps:
Only the USB2 port can be used for reflashing.
In case the used flash disk is not compatible, Axon will boot to the Service mode and the progressive blinking of LEDs is not indicated. In this case it necessary to use different flash disk or the above mentioned Service web interface.