Differences

This shows you the differences between two versions of the page.

--- en:automation:02-glossary:1wire-hidden [2025/04/28 16:16] – [RJ45 connector connection for Unipi 1-Wire] updated wrap ofojt
+++ en:automation:02-glossary:1wire-hidden [2025/04/28 16:18] (current) – [Creating a multi-hub extensive network of 1-Wire sensors] updated wrap ofojt
@@ Line 97: / Line 97: @@
 All described methods are depicted in the schematics below.
-<WRAP center round info 90%>
+<WRAP group center round box 95%>
+{{ :files:img_warning-line_b.png?nolink |}}
+<WRAP half column 13%>
+{{ :en:hw:08_safety-instructions_pseudo-ISO-7010-info.png?nolink |(!)}}
+</WRAP>
+<WRAP half column 83%>
+**Note:** \\
 The sensor features a 4-wire connection to improve the reliability of branched networks. However, it is possible to modify it for 3-wire connection by joining 1W (DATA) wires if needed.
 You can also short-circuit VCC and GND wires to run the sensor in parasite mode with communication through two wires.
+</WRAP>
 </WRAP>
@@ Line 119: / Line 126: @@
 A compact  [[https://www.unipi.technology/1-wire-hub-s-8-porty-p31|8-port 1-Wire hub]] features eight RJ45 ports and allows you to connect multiple 1-Wire thermometers or other sensors with the RJ45 connector. To connect the hub to a controller you can either use a suitable patch cord (on controllers with the RJ45 port) or the [[https://www.unipi.technology/kabelova-1-wire-redukce-rj45-3-pin-svorkovnice-p325|cable reduction]] (on controllers with the newer 3-pin screw terminal).
-<WRAP center round important 90%>
+<WRAP group center round box 95%>
+{{ :files:img_warning-line_b.png?nolink |}}
+<WRAP half column 13%>
+{{ :en:hw:09_safety-instructions_pseudo-ISO-7010-attention.png?nolink |(!)}}
+</WRAP>
+<WRAP half column 83%>
+**Attention:** \\
 It is necessary to follow the correct port order when connecting devices to the hub! Port 1 must be always used as an input port, the remaining ports must not be skipped; otherwise, any devices connected after the skipped port would be cut off from the 1-Wire bus.
 </WRAP>
+</WRAP>
 {{:en:hw:hub_simple_eng.png?600|}}
@@ Line 127: / Line 142: @@
 It is possible to create a chain of multiple hubs if an extensive network of 1-Wire sensors or devices is needed. When interconnecting two hubs the topology stays the same - Port 1 serves as an input while the output is located on the last port in order.
-<WRAP center round important 90%>
+<WRAP group center round box 95%>
+{{ :files:img_warning-line_b.png?nolink |}}
+<WRAP half column 13%>
+{{ :en:hw:09_safety-instructions_pseudo-ISO-7010-attention.png?nolink |(!)}}
+</WRAP>
+<WRAP half column 83%>
+**Attention:** \\
 Any other 1-Wire device connected after the output port will be cut off from the bus!
 </WRAP>
+</WRAP>
 {{:en:hw:hubeng.png?600|}}