This is an old revision of the document!


FIXME

  • Designed for contact measurements of pipeline surface temperature (IP65 protection)
  • Digital water-proof 1W sensor featuring the DS18B20 chip
  • Probe size: (h x w x d): 40 x 12 x 12 mm
  • Holding metal band length: 40 cm
  • Minimal pipe diameter: 20 mm
  • Temperature sensors are suitable for measuring temperature in the range of -10 °C to 85 °C. With reduced accuracy, the sensors can be used in a range of -40°C to 105°C.
  • Cable temperature range: -30 °C to 105 °C
  • Suitable for all Unipi devices with a 1W bus → 4-wire connection
  • Easy connection to the Extension xG18 via RJ45 connector
  • Can be connected to Unipi PLCs using a splitter
  • For more information and tips regarding the sensor connection, please visit the 1-Wire article

Examples of use:

  • Measuring pipeline surface temperature
  • The method of use must be selected in accordance with the temperature and chemical durability of the probe and the input cable

Applicable for:

  • All Unipi PLCs with a 1W bus, including the Unipi 1.1/Lite
    • With Unipi 1W hub and splitter
  • Unipi Extension xG18

A direct connection to Unipi PLC can be performed by cutting away the connector and connecting the sensor to the 1W terminal of Patron or Neuron controllers. Older Neuron controllers and the Unipi 1.1/Lite feature an RJ45 connector, allowing for a direct connection. For more info, please visit the 1-Wire bus and sensor connection.