Backup and restore the OS
Creating an OS back-up on a USB flashdisk
- Prepare a USB flash disk in FAT32 format with a capacity of at least 2 GB
- Start the device in the service mode
- Insert the flash disk and wait for approximately 5 seconds
- In the service interface, click on the Backup to USB flash button located in the Backup dialogue window
- Unipi Gate will start creating the OS backup - the process is indicated by rapid blinking of ACT, TX and RX diodes (demonstration here)
- Upon finishing the process, a “Updated successfully” prompt will be displayed in the service display and blinking of the LEDs will slow down (demonstration here)
- You can now reboot the device using a button on the upper right corner of the web interface
- For loading the backup or uploading the OS into a different device of the same product line, follow the guide below
Note:
If the USB flash disk is not compatible, Unipi Gate will not start the backup process. In that case, you need to use a different flash disk.
Attention:
If you are creating a backup on a device with a lower FID than the one you will flash the backup OS to (e.g. FID 1.1 → FID 2.0), always update the following packages first: g1-kernel-image, g1-u-boot, g1-altboot
Update by the following commands:
sudo apt update sudo apt install g1-kernel-image g1-u-boot g1-altboot
For a Debian 12 based OS you need to update these packages: unipi-kernel, unipi-u-boot, unipi-altboot
sudo apt update sudo apt install unipi-kernel unipi-u-boot unipi-altboot
Restore the OS from back-up on the USB flashdisk
- Unplug the power supply from the device and insert the flash disk into the device's USB port
- Press and hold the SERVICE button on the device's face side
- Plug the power supply back. Unipi Gate will automatically start the OS flashing process indicated by rapid blinking of ACT, TX and RX diodes (demonstration here)
- You can now release the SERVICE button
- Finishing the process is indicated by diodes going off and a reboot of the device