USB

(!)

Attention:
The USB type C port is used only for flashing the eMMC memory and accessing linux service console. Standard data transfer over USB C port is not possible.

(i)

Note:
This article refers only to Unipi Edge units equipped with USB A ports.

Port mapping

The tables below provide information on what USB ports are available and how they are mapped into Linux ports.

USB converters (FTDI, CH34x, PLxxxx and CPxxxx) are also supported by default. For using other gateways or devices, installation of drivers is necessary.

USB1 /dev/serial/by-port/0
USB2 /dev/serial/by-port/1

Technical parameters

Port type A
Version 2.0
Current (max.) 500 mA

(!)

Note:
The USB-A ports have a shared HUB controller with 100 Mbps Ethernet and LTE modem, see block diagram.
Maximum current from a single USB is 500 mA, in case of overload the power supply is cut off.

(!)

Attention:
Do not connect externally powered USB hubs or similar devices. These devices can cause problems and potentially damage the Unipi Edge after rebooting.
If you use an externally powered USB hub make sure to cut the hub's power at the same time as rebooting Unipi Edge.

This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies
(Still can't find what you're looking for?)