This is an old revision of the document!
Each digital output (solid state MOSFET relay) is wired to its own DOx connector. Digital outputs do not possess their own power source and serve only to switch A and B terminals together where the load can be connected. To switch inductive loads, it is necessary to connected adequate protection, e.g. snubber, otherwise there is a risk of possible damage to the device's digital outputs. Both terminals can be wired with both positive and negative polarity. Switching of each output is indicated by LED with the label and number corresponding to the output.
Note:
Digital outputs can be configured to PWM mode (pulse width modulation) using a suitable SW (Mervis, EVOK or by directly editing the Modbus registers).
Connection
The following pictures describe the basic connection of digital output:
Attention:
To switch some loads it is necessary to add adequate protection elements, e.g. snubber!
SINK
SOURCE
