en:hw:din-mounting-bopla-hidden [Unipi technology Knowledge Base]

This is an old revision of the document!

$/!\$

Warning:
Prior to mounting, make sure that the environment is disconnected from all power sources.

If the holder for DIN rail is not installed, it must be mounted first with the supplied screws (M3x7, DIN 84, ZN) so that the hook of the extension spring is on the bottom and facing towards front of the device.

DIN holder installation

</WRAP>

To install unit on the DIN rail, slide the unit onto the rail from above (in the direction of arrow 1 in the picture below) and then pull the extension spring down with screwdriver and lightly push the device (in the direction of arrow 2 in the picture below) until flush with DIN rail.

Mounting on DIN rail ;#;

(!)

Attention:
Avoid pressure on the inputs/outputs as they could be mechanically damaged.

$/!\$

Caution:
Make sure that the upper edge of the DIN rail runs between the spring and the rear of the DIN holder (see figure above). Improper mounting of the DIN bracket can cause injury when mounted on the DIN rail.