This is an old revision of the document!
![/!\](/_media/en:hw:07_safety-instructions_iso-7010-m021.png "/!\")
Warning:
Prior to mounting, make sure that the environment is disconnected from all power sources.
If the holder for DIN rail is not installed, it must be mounted first with the supplied screws (M3x6, PH1) so that the hook of the extension spring is on the bottom and facing towards front of the device.
DIN holder installation
To install unit on the DIN rail, slide the unit onto the rail from above (in the direction of arrow 1 in the picture below) and then pull the extension spring down with screwdriver and lightly push the device (in the direction of arrow 2 in the picture below) until flush with DIN rail.
Mounting on DIN rail
Attention:
Avoid pressure on the terminals as they could be mechanically damaged.
