Toto je starší verze dokumentu!

FIXME This page is not fully translated, yet. Please help completing the translation.
(remove this paragraph once the translation is finished)

/!\

Warning:
Prior to mounting, make sure that the environment is disconnected from all power sources.

If the holder for DIN rail is not installed, it must be mounted first with the supplied screws (2x M3x7, button head) so that the hook of the extension spring is on the bottom and facing towards front of the device.

DIN holder installation

To install unit on the DIN rail, slide the unit onto the rail from above (in the direction of arrow 1 in the picture below) and then pull the extension spring down with screwdriver and lightly push the device (in the direction of arrow 2 in the picture below) until flush with DIN rail.

Mounting on DIN rail

(!)

Attention:
Avoid pressure on the terminals as they could be mechanically damaged.

Tento web používá cookies. Používáním těchto stránek souhlasíte s ukládáním cookies do vašeho počítače. Také berete na vědomí, že jste si přečetli a porozuměli našim Zásadám ochrany osobních údajů. Pokud nesouhlasíte s odchodem z webu.Více informací
(Stále nemůžete najít, co jste hledali?)